Lucent Technologies PARTNER Advanced Communications System Release 1.0 Programming And Use Instructions page 243

Using
(See Figure 2-3 in Chapter 2 for the location of special programming buttons
s
such as
To initiate a restore:
1. Power down the system:
If you have a 5-Slot carrier, move the On/Off switch to the "Off" position
("O").
If you have a Stand-Alone PARTNER ACS processor module
configuration or a 2-Slot carrier, unplug the power cord from the power
jack.
2. Insert the correct Backup/Restore PC Card in Slot 2 of the PARTNER ACS
processor module; if there is a PC Card in Slot 1, remove it. (If the system
detects cards in both slots, it will use Slot 1 for the Restore .)
3. Power up the system:
If you have a 5-Slot carrier, move the On/Off switch to the "On" position
("I").
If you have a Stand-Alone PARTNER ACS processor module
configuration or a 2-Slot carrier, plug the power cord into the power
jack.
f 0 0 s s # 1 2 5
4. Press
or 11.
The top line of the display shows Sys Set Restore or System
Settings Restore .
If no PC Card is present in the PARTNER ACS processor module, the error
message Insert Valid Card is displayed. Repeat this procedure from
Step 1, inserting a Backup/Restore PC Card at Step 2. You must power
down the system before removing or inserting a Backup/Restore PC
Card.
You are prompted to choose the backup file you want to use for the
restore. The bottom line of the display shows 1 MAN.mmddyy, where
mmddyy represents the date of the manual backup on this card.
5. To change to the file created by an automatic backup, press
The bottom line of the display shows 2 AUTO.mmddyy,where mmddyy
represents the date of the automatic backup on this card.
NOTE:
If the date of the file (AUTO. mmddyy or MAN. mmddyy ) indicates that this
is not the file you intended to use, repeat this procedure from Step 1 and
insert a different Backup/Restore PC Card in Step 2. You must power
down the system before removing or inserting a Backup/Restore PC
Card.
If the Backup/Restore PC Card is fresh from the factory, and no backups
have been recorded on it yet, the filenames will be MAN.****** and
5-150
Restore Programming (#125)
e
and on system phones.)
at extension 10
2.