Lucent Technologies PARTNER Advanced Communications System Release 1.0 Programming And Use Instructions page 205

Valid Entries
1 = Assigned
2 = Not Assigned
3 = Select Button (then press a line button to assign the line to that button)
Programming
(See Figure 2-3 in Chapter 2 for the location of special programming buttons
such as s
To assign lines to a specific extension:
f 0 0 s s # 3 0 1
1. Press
or 11.
2. Enter the extension number to be programmed. For example, to program
extension 15, press
The red light next to each button that has a line assigned is on steady. To
remove all existing line assignments, press
3. Enter the line number to be assigned. For example, to select line 1,
0 1
press
4. At this point:
If you want to assign the line to the first available button with lights,
press
Line Assignment 15 L01
1 Assigned
If you want to remove a line assignment, press
similar to the following appears:
Line Assignment 15 L01
2 Not Assigned
If you want to assign the line to a specific button, press
similar to the following appears:
Line Assignment 15 L01
3 Select a Button
Then press a button with lights to assign the line to that button. If you
use option 3 after a line has been assigned, the line moves from the old
button to the new button you select.
5. At this point:
To program another line for this extension, press
until the line number shows on the display. Then repeat Step 4.
To program another extension, press
begin at Step 2.
6. Select another procedure or exit programming mode.
5-112
Line Assignment (#301)
and e on system phones.)
1 5
.
.
D
until the display reads:
at extension 10
r
before selecting a line.
D
until a display
3 . A display
n p
or
N P
and