Lucent Technologies PARTNER Advanced Communications System Release 1.0 Programming And Use Instructions page 226

Programming
(See Figure 2-3 in Chapter 2 for the location of special programming buttons
s
such as
To program a Night Service Button at extension 10:
f 0 0 s s # 5 0 3
1. Press
or 11.
2. At this point:
If you want to assign Night Service to the first available button, press
D
Night Service Button
1 Assigned - Ext10
If you want to remove the Night Service button assignment, press
D
Night Service Button
2 Not Assigned
If you want to assign Night Service to a specific button, press
display similar to the following appears:
Night Service Button
3 Select a Button
Then press a programmable button with lights to assign Night Service
to that button.
3. Select another procedure or exit programming mode.
4. Label the Night Service button at extension 10.
Using
To turn Night Service on:
1. Press the Night Service button at extension 10.
If a System Password is programmed, the green light next to the button
flashes; you must continue with Step 2.
If no System Password is programmed, the green light is on steady and
Night Service is on.
2. Enter the password.
The green light is on steady. Night Service is on.
e
and on system phones.)
until a display similar to the following appears:
until a display similar to the following appears:
at extension 10
Night Service Button (#503)
3
. A
5-133