Lucent Technologies PARTNER Advanced Communications System Release 1.0 Programming And Use Instructions page 142

Using
System Phone
1. Set up the call to the first party. (You can call the party, pick up the call from
hold, or answer an incoming call.)
You are connected with the first party.
C
2. Press
The first party is now on hold.
3. Set up the call to the second party.
You are connected with the second party. If you are adding an inside
party to a call, you must wait until the party answers.
C
4. Press
You can now speak with the first and second parties.
5. Repeat Steps 2 through 4 to add more parties.
Standard Phone
1. Set up the call to the first party. (You can call the party, pick up the call from
hold, or answer an incoming call.)
You are connected with the first party.
2. Press the switchhook down once rapidly.
The first party is now on hold. You hear intercom dial tone.
3. To add an outside party, dial
busy or does not answer, hang up and the first party rings back.
To add an inside party, dial the two-digit extension number. If the
extension is busy or does not answer, press the switchhook down once
rapidly and you are reconnected with the first party.
4. When the second party answers, press the switchhook down once rapidly.
You are now connected with both parties.
5. Repeat Steps 2 through 4 to add more parties.
.
again to add the second party to the call.
9
plus the outside number. If the number is
5-49
Conference Calls