Changing Programming Type; Remote Programming - Lucent Technologies PARTNER Advanced Communications System Release 1.0 Programming And Use Instructions

Changing Programming Type

When you are in programming mode, you can move between System
Programming and Centralized Telephone Programming. To change to
Centralized Telephone Programming when you are in System Programming,
press c
Centralized Telephone Programming, press

Remote Programming

The system permits programming from a remote location using an auxiliary
device called the Remote Administration Unit (RAU). Remote programming
requires the installation of two RAUs—one at your site and one at the location
from which the programming is to be done. For more information about remote
programming, see the PARTNER Communications System Remote
Administration Unit Installation and Use guide.
. To move back to System Programming when you are in
c s
then
Programming
.
2-19