Xerox 6250DT - Phaser Color Laser Printer Service Manual page 96

Test
Tray 1 (MPT)
Feed Solenoid
Tray 2 Feed
Solenoid
Tray 3 Feed
Solenoid
Tray 4 Feed
Solenoid
Maintenance - Cleans the Intermediate Transfer Unit within the Imaging Unit.
Clean Imaging
Unit IDT 1
Clean Imaging
Unit IDT 2
NVRAM Access - This menu lets you read, set or reset the following values:
PostScript
NVRAM Reset
MCU NAVRAM
Store/Restore
Toner Install
Dates
Toner CRUM
Check
CRU Life
Reset
Error Messages and Codes
Front Panel Display and Test Definition
Solenoid is: ON
Solenoid is: OFF
Printing.....
Resetting PostScript NVRAM...
Are you sure?
Yes
NO
Save Engine NAVRAM
Restore Engine NAVRAM
Black Toner Install Date
Cyan Toner Install Date
Magenta Toner Install Date
Yellow Toner Install Date
(<Color> Not) Genuine Xerox Toner
Sets life count of transfer roller to
unused.
Audible verification of the Solenoid
function.
"Printing" is displayed on the Front
Panel during the IDT cleaning
cycle.
The test continuously cycles paper
through the printer until the Cancel
button is pressed.
Restores the Printers setup values
to their factory defaults. For more
information on resetting NVRAM,
See "Resetting NVRAM" on
page 6-4.
Saves critical engine parameters;
printer installation date, printer
page count, imaging unit life count,
transfer roller life count to Image
Processor Board before replacing
the Engine Control Board.
Restores previously saved critical
engine parameters to the Engine
Control Board after replacement.
Allows toner cartridge install dates
to be viewed, or to be changed
when current value is corrupted or
obviously incorrect.
Verifies that genuine Xerox toner is
installed in the printer.
Resets the life count stored in
NAVRAM.
3-15