Ctd (Adc) Sensor (Pl 5.1.11) - Xerox 6250DT - Phaser Color Laser Printer Service Manual

CTD (ADC) Sensor (PL 5.1.11)

1. Open Door A.
2.
Remove the Transfer Roller Assembly (Routine Maintenance Item) (page 8-4).
3.
Release the 4 tabs securing the CTD Sensor Assembly (item #1) to the Chute
Assembly In (item #2) .
Caution
The CTD Sensor is under spring tension, be careful not to damage or lose the
springs.
4.
Raise the sensor slightly to disconnect P/J136 (yellow) from the Chute Assembly
In.
5.
Remove the CTD Sensor.
6.
Remove the springs (item #3) from the Sensor CTD (ADC) Assembly.
2
Replacement Notes
Note
The left spring has an aligning post on the Chute Assembly In.
8-42
3
Phaser 6250 Color Laser Printer Service Manual
1
3
6250-170