Jam At Duplex: Jam D - Xerox 6250DT - Phaser Color Laser Printer Service Manual

Jam at Duplex: Jam D

■
Check for any obstructions or debris in the duplexer or paper path.
■
Cycle printer power
■
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Duplex Sensor, PL 6.1.4
Actuator Kit, PL 15.1
Chute Assembly Exit, PL 7.1.7
Troubleshooting Procedure Table
Steps Actions and Questions
Check the following for evidence of fault
1
or damage:
Chute Assembly Exit, PL 7.1.7
Duplex Motor Assembly, PL 7.1.8
Duplex Sensor, PL 6.1.4
Duplex Actuator, PL 6.1.5
Chute Assembly Out, PL 6.1.1
Use service diagnostics to test the Duplex
2
Sensor.
Does the sensor function correctly?
Does the printer function correctly after
3
the Duplex Sensor is replaced?
Block the Duplex Sensor and verify the
4
voltage between J 139-3<=>J 139-2 is
0 VDC.
Check the Front 2 Harness for continuity.
5
See "Paper Feed" on page 10-25.
Check P 139<=>J 13 on the Front 1A
6
Harness for continuity.
See "Paper Feed" on page 10-25.
If possible, print 1 sheet of paper in
7
Duplex Mode and check to see if the
sheet has reversed in the printer.
Error Messages and Codes
Wiring and Plug/Jack Map References
"Drive Section" on page 10-18
"Paper Feed" on page 10-25
"Map 1" on page 10-6
Yes
Replace the
damaged part.
Go to Step 7.
Complete
Go to Step 6.
Go to Step 6.
Replace the
Engine Control
Board,
page 8-107.
Replace the Chute
Assembly Exit,
page 8-62.
No
Go to Step 2.
Replace the
sensor and
Go to Step [3].
Go to Step 4.
Go to Step 5.
Replace the
Front 2 Harness
Assembly, PL
6.1.2.
Replace the
Assembly, Front
1A, PL 13.1.7.
Go to Step 8.
3-21