Card Cage - Xerox 6250DT - Phaser Color Laser Printer Service Manual

Card Cage

Note
You do not need to remove the Laser Unit.
Caution
Remove the Chute Assembly Registration and the Housing Assembly Bias
PRIOR to removing the Card Cage to prevent damaging the Bias Springs.
1.
Remove the Chute Assembly Registration (page 8-71).
2.
Remove the Housing Assembly Bias (page 8-69).
3.
Disconnect P/J151 from the Laser Unit.
4.
Disconnect P/J3411 from the CRUM Reader located above the Card Cage.
5. Disconnect P/J210 from the Paper Tray Feeder on the right side of the printer.
6.
Disconnect P/J 41 and P/J 42 from the Motor Driver Board.
7.
Disconnect P/J 164 and P/J 168 from the LVPS.
8.
Remove the cable guide retainers and remove the cable guide on the right side of
the printer above the power switch.
9. Remove P/J 5011 from the Sub-HVPS, and free it from the cable clamp.
10.
Disconnect P/J19 (blue) from the Engine Control Board (under the Housing
Assembly Electric).
Service Parts Disassembly
6250-234
8-103