Exit Actuator (Fuser) (Pl 8.1.7) - Xerox 6250DT - Phaser Color Laser Printer Service Manual

Exit Actuator (Fuser) (PL 8.1.7)

1. Open Door B and remove the Fuser Assembly.
2.
Lift the tab that secures the bearing to the left side of the Fuser Exit Roller shaft
and remove the bearing.
3.
Move the exit roller slightly out of the way.
4.
From the outside of the fuser cover, push the Exit Actuator out of the retaining
clips being careful not to drop the spring into the fuser.
5. Remove the Actuator Spring.
Reassembly Notes
Note
Ensure that the spring is positioned as shown in the figure.
8-66 Phaser 6250 Color Laser Printer Service Manual
6250-198