Configuring A Raid Controller To Use In-Band Scsi - Acer Altos RAIDWatch Manual

2.7.1 Configuring a RAID Controller to Use In-band SCSI

2.7.1.1 RAID Controller Adjustments
Some adjustments must be made to the RAID controller settings before the two can communicate
using SCSI commands. The RAID controller settings can be changed using the RS232.
From the Main Menu, press *
Configuration Parameters."
Press <Enter>; and then use the *
Parameters." Then press <Enter>.
You will need to make adjustments in the following four submenus: Peripheral Device Type,
Peripheral Device Qualifier, Device Support for Removable Media, and LUN Application. Different
host operating systems require different adjustments. Look at the table below to find the proper
settings for your host operating system.
7
Table 2–2
Windows NT® 4.0
NetWare® 4.x/
Windows 2000/XP
SCO OpenServer
5.0x
SCO
UnixWare 2.1x,
UnixWare 7
Solaris™ 2.5.x/2.6
(x86 and SPARC)
Linux
Up and Down
*
Arrows
up down
or
up
or
Peripheral Device Type Parameters
0x1f
0x03
0x7f
0x03
0x7f
0x03
arrows to select "View and Edit
down
arrows to select "Host-side SCSI
connected
connected
connected either is okay
connected either is okay
connected either is okay
connected
View and Edit
Config Parms
Host Side SCSI
Parameters . .
disabled All Undefined
LUNs
disabled All Undefined
LUNs
All Undefined
LUNs
All Undefined
LUNs
All Undefined
LUNs
enabled All Undefined
LUNs
Installation
27