Table of Contents
Advertisement
Altos RAIDWatch User Guide
11.4.2 Level 2 Severity Events (examples)
• SCSI Target Select Timeout
• SCSI Target Unexpected Disconnect
• SCSI Target Timed Out
• SCSI Target Parity Error
• SCSI Target Not Ready Error
• SCSI Target Media Error
• SCSI Target Hardware Error
• SCSI Target Unit Attention
• SCSI Target Unexpected Sense Date
• SCSI Target Block Reassignment Failure
• SCSI Target Unexpected Data Over/Underrun
• Drive SCSI Unrecognized Event
11.4.3 Level 3 Severity Events (example)
• Drive Failure
11.5 Configuring Notification Options
The configuration of NPC notification modes has been fully described in Chapter 3 , "Configuration
Options", on page 31. Please refer to this chapter to see how to configure the following NPC
configuration options.
• Modem
• Fax
• Pager
• Broadcast
• E-Mail
• SNMP
11.5.1 Configuring Modem Settings
NPC needs to be configured with the proper settings for the host's fax/modem if fax or pager
notification is going to be used.
NPC modem settings include Serial Port and Baud Rate. If multiple modems are available on
different COM ports, each one can be entered. The NPC settings of each of these variables must
identically match the host's fax/modem configuration settings.
• Serial Port: choose from COM1 to COM16 in the drop box.
• Baud Rate: choose 4800, 9600, 19200, 38400, or 57600 in the drop box.
148
Note: The current version of NPC does not include event notification configuration based on
event severity.
Advertisement
Table of Contents
