Table of Contents
Advertisement
3.5 NPC Settings
To configure the
Setting" tab from the tab menu at the top of Figure 3–3. the "Notification Process Center" screen
shown in Figure 3–6 will appear.
Figure 3–6
There are seven sub-tabs at the top of the
five different (Fax, Pager, Broadcast, Email, and SNMP Traps) means of informing RAID managers
that an event has occurred, the Agent and the Event Log can also be configured by the user.
In order to use fax or pager notification, Modem parameters must also be set. For NT servers,
Widows Messaging and Personal Fax must be installed and running for NPC to work. If NPC will not
be used, skip these steps.
3.5.1 Agent
After opening the NPC Settings window shown in Figure 3–6, the Agent window will immediately
appear. The
• Host Name: This is the controller's IP address.
• Port Number: This is the port number the Altos RAIDWatch Manager stations will use to
communicate with the Primary Agent.
Notification Process Center (NPC)
NPC Settings
Host Name
and the
Port Number
settings, select "Notification Process Center
NPC Settings
window shown in Figure 3–6. Along with
must be configured.
Configuration Options
37
Advertisement
Table of Contents
