Table of Contents
Advertisement
Figure 3–2
It can be seen that the difference between Figure 3–1 and Figure 3–2 is the "Enable SSL."
Note
Enabling the SSL can only be done when the GUI is installed on the controller as an Applet Only.
3.3 Primary Agent Configuration
To configure the Primary agent settings, select
of Figure 3–3. Two sub-tabs, "Base Settings" and "Managed Secondary List".
3.3.1 Base Settings
The "Base Settings" are shown in Figure 3–3.
• Port Number: This is the port number the Altos RAIDWatch Manager stations will use to
communicate with the Primary Agent.
• Enable Redundant: This is selected to enable primary agent/NPC on another server for the
precaution that a Primary Agent/NPC might fail and, as the consequence, fatal system events
might then occur unnoticed.
• SSL Enable: This option, only available if the controller is installed as an applet on the
controller, enables the Secure Sockets Layer (SSL). To enable it just point the mouse to the
square and double click. To disable it, do the same.
Applet Only Configuration Panel
"Primary Agent"
tab from the tab menu at the top
Configuration Options
33
Advertisement
Table of Contents
