Table of Contents
Advertisement
up
down
Press *
or
arrows to select "LUN Application"; and then press <Enter>.
The default setting is "All Undefine LUN.".
Press <Enter> and use *
Press <Enter> to accept. The screen should display the following message.
The RAID controller adjustments necessary to use in-band SCSI have been completed.
If an Out-of-Band connection is being used, then it is recommended Peripheral Device Type is set to
No Device (0x7F)
up
down
or
arrows to select "Undefine LUN-0's."
Installation
LUN Application-
All Undefine LUN
Applies to
?
Undefine LUN - 0's
LUN Application
Undefine LUN - 0's
29
Advertisement
Table of Contents
