Table of Contents
Advertisement
Chapter 3
Configuration Options
3.1 Introduction
This chapter describes the Altos RAIDWatch configuration options. There are a number of different
items that users can configure. These include primary and secondary agents and the Notification
Processing Center.
Note
If during installation (see section 2.4, "Software Setup", on page 14), you selected the Out of Band
option, since neither the primary nor secondary agents were installed and only the GUI was
installed, these configuration options will not be available to you.
• Accessing the Configuration Panel, 3.2 on page 31,
• Primary Agent Configuration, 3.3 on page 33
• Secondary Agent Settings, 3.4 on page 36,
• NPC Settings, 3.5 on page 37
• Rebooting the Controller, 3.6 on page 45
3.2 Accessing the Configuration Panel
3.2.1 Using Windows – Altos RAIDWatch Installed as In-Band
If, during the installation process outlined in Chapter 2, the In-Band option was selected, the In-
Band SCSI driver, associated agents and configuration tools were installed on the local computer.
To access the configuration tools using Windows, please do the following:
1
Open the directory in which the Altos RAIDWatch GUI was installed. This default directory was
selected during the installation process.
Configuration Options
31
Advertisement
Table of Contents
