Table of Contents
Advertisement
Altos RAIDWatch User Guide
Figure 3–16
3.5.6.1
Base Settings
To configure the "Base Settings" select the
configuration options shown in Figure 3–16 will appear.
• Enable: To enable the broadcast settings, select the "Enable" box in the middle of the
3.5.6.2
Broadcasting List
To configure the "Broadcasting List" select the
configuration options shown in Figure 3–17 will appear.
Figure 3–17
• Host IP/Name: The IP address a broadcast message will be sent to.
• Severity: The parameter used to determine what levels of events to be sent via Broadcast (1,
• Host Name: Shows a list of all the IP addresses that the NPC will use to send a message to. Both
44
Enable Broadcast settings
Broadcast Settings
window.
Broadcasting List Settings
all levels; 2, Warning and Alert; 3, only Alert).
the IP addresses and the severity of the messages that will be sent to the address shown are
listed.
Base Settings
sub-tab from Figure 3–16 and the
Broadcasting List
sub-tab from.Figure 3–16. The
Advertisement
Table of Contents
