Table of Contents
Advertisement
Altos RAIDWatch User Guide
Figure 2–9
2.4.5 Applet-Only Installation
2.4.5.1
Reserved Space
If the
controller and therefore space for these files must be reserved. If you have not already reserved the
1
Stop the Altos RAIDWatch Installation Program. To do this, use the cursor to click the "Stop" button
in Figure 2–3.
2
Use either the MUI or the terminal emulation program, to access the pre-installed firmware on the
controller.
3
Use the FW to create a logical array (please refer to your RAID Controller Operating Manual). Make
sure that you reserve a space of at least 256MB. This reserved space is required for the Altos
RAIDWatch Files that will be transferred to the RAID Controller.
Caution
If you do not reserve a space of at least 256MB, you will not be able to transfer the necessary Altos
RAIDWatch files to the controller and will therefore be unable to use the Altos RAIDWatch
Program.
2.4.5.2
Applet Only Installation
1
Once space has been reserved on the controller, follow the instructions outlined in Section 2.4.2
until the
22
Successful Installation
Applet Only
option is selected, Altos RAIDWatch files will be installed directly onto the
space on the controller then do so now. Follow these steps:
Installation Options
screen shown in Figure 2–3 appears.
Advertisement
Table of Contents
