Table of Contents
Advertisement
Altos RAIDWatch User Guide
Figure 9–24
3
A Create WWN Name Mapping window, as shown in Figure 9–25, should appear in the content
panel.
Figure 9–25
4
The following WWN parameters need to be entered.
• WWN Name: The WWN name is selected by the user. Enter the name you wish to assign to the
• Host ID: There are two ways in which a user can select the Host ID, manually or automatically.
5
Once the new WWNs have been added, if you select the LUN Table tab all the newly entered WWNs
should be listed.
9.3.4 Deleting an Extended LUN Mapping or WWN Name
1
Deleting an Extended LUN Mapping or WWN is similar to deleting a normal LUN Mapping. Follow
the steps listed in Section 1 above to access the LUN Map Table shown in Figure 9–3.
132
WWN Tabs
Create WWN Name Mapping
HBA.
– Manually: Refer to the documentation that came with the HBA and enter the Host ID that
is given in this document.
– Automatically: Select the Host ID from the Host ID Pool by clicking on the ID you wish to
select. The ID's shown in the pool are automatically detected by the controller's embedded
firmware.
Advertisement
Table of Contents
