Status - Panasonic PT-DS100XE Operating Instructions Manual

PROJECTOR SETUP menu
When the D7700 Series is selected
Q
1. Press ▲▼ to select input signal
[DVI-D] or [SDI].
[RGB1], [RGB2], [VIDEO], [S-VIDEO] and
z
[HDMI] cannot be selected.
Since [RGB1], [RGB2], [VIDEO], and [S-VIDEO]
are already installed on the projector, another
input signal change command cannot be
assigned.
[SDI] is not shown for PT-DW90XE.
z
2. Press ◄► to select the input signal
change command to be assigned to
the selected input signal.
The signal change command can be selected
z
to either [AUX] or [NONE].
The same input signal change command
z
cannot be assigned to both [DVI-D] and [SDI].

STATUS

Displays the status of the projector.
1 ) Press ▲▼ to select [STATUS].
2 ) Press <ENTER> button.
3 ) Press ◄► to move to the next page.
INPUT
SIGNAL NAME
SIGNAL
FREQUENCY
PROJECTOR
RUNTIME
LAMP1
*1
LAMP2
*1
INTAKE
AIR TEMP.
OPTICS
MODULE TEMP.
AROUND
LAMP TEMP.
REMAINING
FILTER
QUANTITY *2
PROJECTOR
TYPE
SERIAL
NUMBER
84
- ENGLISH
Displays the input selection
state.
Displays the input signal name.
Displays the frequency of the
input signal.
Displays the projector runtime.
Displays the lighting time of
LAMP1.
Displays the lighting time of
LAMP2.
Displays the intake air
temperature of the projector.
Displays the temperature inside
the projector.
Displays the temperature around
the lamp of the projector.
Displays the filter remaining
quantity.
Displays type of projector.
Displays the serial number of the
projector.
LAMP UNIT Displays the component number
MODEL NO. of the lamp unit.
LAMP1 SERIAL Displays the serial number for
NUMBER lamp1.
LAMP2 SERIAL
Displays the serial number for
NUMBER lamp2.
Displays the main version of the
MAIN VERSION
firmware of the projector unit.
Displays the sub version of the
SUB VERSION
firmware of the projector unit.
NETWORK Displays the network version of
VERSION the projector unit.
EMULATE Displays the set emulate mode.
POWER ON TIMES :
z
Displays the number of times
the power has been turned
on.
LAMP1 ON :
z
ON COUNT
Displays the number of times
LAMP1 has been lit.
LAMP2 ON :
z
Displays the number of times
LAMP2 has been lit.
Displays the lighting time of
LAMP1
LAMP1. (HIGH or LOW)
Displays the lighting time of
LAMP2
LAMP2. (HIGH or LOW)
NUMBER OF Displays the number of
ENTRY SIGNAL
registered signals.
REMOTE2 Displays [REMOTE 2 IN] control

STATUS

status.
AC VOLTAGE Displays the AC voltage state.
*1 :
Lamp replacement time =
LAMP POWER [HIGH] lighting time +
(LAMP POWER [LOW] lighting time x 3 ÷ 4)
*2 : REMAINING FILTER QUANTITY
If the remaining quantity of ACF becomes 8%,
the status display turns yellow. If the remaining
quantity becomes 0%, the display turns red.
If the residual filter indication becomes yellow,
the remaining usable time is about 200 hours.
The time of 200 hours is for reference only. It
depends on the usage environment.