Waveform Monitor (Pt-Dz110Xe Only); Waveform Monitor - Panasonic PT-DS100XE Operating Instructions Manual

4 ) Press ◄► to adjust [SCREEN
POSITION].
In the case of the PT-DZ110XE :
z
When [SCREEN FORMAT] is [16 : 9]
Adjustment range: - 60 to +60
When [SCREEN FORMAT] is [4 : 3]
Adjustment range: - 160 to +160
In the case of the PT-DS100XE, you can adjust
z
the setting from - 132 to +131.
Note
[SCREEN POSITION] cannot be adjusted when
z
[SCREEN FORMAT] is [16 : 10] (PT-DZ110XE) or [4 : 3]
(PT-DS100XE).

WAVEFORM MONITOR

(PT-DZ110XE only)
This function displays the waveform of the input signal
from a connected peripheral device.
You can check if the image output (BRIGHTNESS)
signal level is within the range recommended by this
projector and adjust it as necessary.
1 ) Press ▲▼ to select [WAVEFORM
MONITOR].
2 ) Press ◄► to switch [WAVEFORM
MONITOR].
The setting will change as follows each time
z
◄► is pressed.
OFF
3 ) Press the <MENU> button twice to turn
off the menu screen.
4 ) Select any horizontal line with the ▲▼.
Line selection
(BRIGHTNRSS)
Line selection
(BLUE)
Note
Setting can also be performed using the <FUNCTION>
z
button. ( Æ page 85)
J
Project the brightness adjustment signal from, for
example, a commercially available adjustment disc
(0% [0 IRE or 7.5 IRE] - 100 % [100 IRE]) and adjust
the waveform.
Q
1 )
2 )
3 )
ON
Q
1 )
2 )
Line selection
(RED)
3 )
Line selection
(GREEN)
DISPLAY OPTION menu
Adjust the waveform
100%
50%
0%
Monitor position
Adjusting brightness
Select [Line selection (BRIGHTNRSS)]
in the waveform monitor.
Adjust the black level.
In [BRIGHTNESS] of on-screen menu
z
[PICTURE], adjust the 0 % of the black level of
the image signal to the position corresponding
to 0% on the waveform monitor.
Adjust the white level.
In [CONTRAST] of on-screen menu [PICTURE],
z
adjust the 100 % of the while level of the image
signal to the position corresponding to 100 %
on the waveform monitor.
Adjusting RED, GREEN, and BLUE
Set [COLOR TEMPERATURE] to
[USER1] or [USER2]. (
Select [Line selection (RED)] in the
waveform monitor.
Adjust the dark portion of RED.
In [RED] of [WHITE BALANCE LOW], adjust
z
the 0 % of the black level of the image signal
to the position corresponding to 0 % on the
waveform monitor. ( Æ
Image
displayable
area
Æ page 55)
page 55)
ENGLISH -
71