Remote 2 In Terminal - Panasonic PT-DS100XE Operating Instructions Manual

REMOTE 2 IN terminal

Using the [REMOTE 2 IN] terminal provided on the connection terminals of the main unit, it is possible to operate
the projector from a control panel etc. furnished in a distant location where infrared remote control signal cannot
be received.
Projector set up in a meeting room
Pin assignments and control
J
D-Sub 9-pin (Outside view)
Attention
Be sure to short-circuit Pins
z
When pin and pin are short-circuited, the following buttons on the projector's control panel and on the remote control
z
cannot be used.
<POWER ON ( I )> button, <SHUTTER> button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either.
When pin and pin are short-circuited and then any one of pins
z
on the projector's control panel and on the remote control cannot be used.
<POWER> button, <INPUT SELECT> buttons (RGB1, RGB2, DVI-D, SDI, VIDEO, S-VIDEO), <SHUTTER> button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either.
The above is explanation in the case where "REMOTE2 MODE" of "PROJECTOR SETUP"
z
"STANDARD".
Pin No. Signal name
POWER
S-VIDEO
SHUTTER
RST/SET
and when controlling.
Technical Information
Remote control
Remote control/External control
Standby
RGB1
RGB2
DVI-D
Control panel located in a different room
Open (H)
GND —
OFF
RGB1 Other
RGB2 Other
VIDEO Other
Other
DVI Other
OFF
Controlled by
remote control
to is short-circuited to pin
External control
ON
LAMP
VIDEO
S-VIDEO
Short (L)
GND
ON
RGB1
RGB2
VIDEO
S-VIDEO
DVI
ON
Controlled by
external contact
, the following buttons
Æ
( page 85) is set to
ENGLISH -
121