Setting Projector Id Number To Remote Control; Using A Wired Remote Control - Panasonic PT-DS100XE Operating Instructions Manual

Setting projector ID number
to remote control
Each projector can be assigned a unique ID number,
and the handheld remote' s number must be set to
match the intended projector.
The ID number of the projector is set to "ALL" on
shipping, and use the ID ALL button of the remote
control when using only a single projector.
1 ) Press <ID SET> button, and the
projector (s) will display it's current ID
number onscreen. Within 5 seconds,
use the numeric keys (0-9) to match
the Remote's ID number with that of
the desired projector.
Attention
Do not press <ID SET> button accidentally or carelessly
z
because the ID number on the remote control can be set
even when no projector is around.
If you do not enter the 2 digits ID number within 5
z
seconds after <ID SET> button has been pressed, the ID
will remain at the number that was set before <ID SET>
button was pressed.
Your specified ID number is stored in the remote control
z
unit unless another one is specified later. However, the
stored ID will be erased if the batteries of the remote
control are left exhausted. When the batteries are
replaced, set the same ID number again.
The ID number can be set to "ALL" or from "1" to "64".
z
Note
Refer to "PROJECTOR ID" of "PROJECTOR SETUP
z
Æ
menu" ( page 76).
About Your Projector

Using a wired remote control

When multiple projectors are connected as part of the
system, connect to units with a M3 stereo mini jack
commercial cable to simultaneously control multiple
main units with a single remote control through the
REMOTE 1 IN/OUT terminal. It is effective to use the
wired remote control in the environment in which an
obstacle stands in the light path or where devices are
susceptible to outside light.
Connect to the remote
control wired terminal
M3 stereo mini jack cable
(commercial)
Attention
Use 2 core shielded cable of length of 15 m or less. If the
z
length of the cable exceeds 15 m (49' 2"), the shielding
of the cable may not be sufficient and the remote control
may not work.
Remote Control
Connect to the
secondary projector
Connection terminals
ENGLISH -
21