Color Temperature; Color Temperature Default - Panasonic PT-DS100XE Operating Instructions Manual

COLOR TEMPERATURE

You can adjust the white balance of the projected
image.
1 ) Press ▲▼ to select [COLOR
TEMPERATURE].
2 ) Press ◄► or <ENTER> button.
The [COLOR TEMPERATURE] individual
z
adjustment screen will be displayed.
3 ) Press ◄► to switch [COLOR
TEMPERATURE].
The setting will change as follows each time
z
◄► is pressed.
DEFAULT USER1
Û
(in units of 100K)
9300K
: [DEFAULT] cannot be selected when the
Û
[PICTRUE MODE] has been set to [USER] or
[DICOM SIM.].
Note
When any setting other than [OFF] has been selected
z
for [COLOR MATCHING] (
TEMPERATURE] setting is fixed to [USER1].
The value of color temperature is for reference only.
z
To further adjust toward the
J
desired white balance
4 ) Select [USER1] or [USER2] in Step 3).
5 ) Press <ENTER> button.
The [COLOR TEMPERATURE] screen will be
z
displayed.
6 ) Press ▲▼ to select [WHITE
BALANCE].
7 ) Press <ENTER> button.
The [WHITE BALANCE] screen will be
z
displayed.
8 ) Press ▲▼ to select [WHITE
BALANCE HIGH] or [WHITE
BALANCE LOW].
9 ) Press <ENTER> button.
The [WHITE BALANCE HIGH (or LOW)]
z
screen will be displayed.
10 ) Press ▲▼ to select [RED], [GREEN]
or [BLUE].
USER2
3200K
Æ page 69), the [COLOR
11 ) Press ◄► to adjust the level.
Item Operation Adjustment
Press ►. Deepens red.
RED
Press ◄. Weakens red.
Press ►. Deepens green.
GREEN
Press ◄. Weakens green.
Press ►. Deepens blue.
BLUE
Press ◄. Weakens blue.
Note
All colors will not be displayed properly unless adequate
z
adjustment is made. If the adjustment does not look
suitable, you can press <DEFAULT> button to return the
setting for the selected item only to the factory default
setting.
The [COLOR TEMPERATURE] cannot be adjusted
z
for the internal test pattern (
project the input signal when adjusting the [COLOR
TEMPERATURE].
Changing the name of [USER 1]
J
or [USER 2]
1. Select [USER1] or [USER2] in step 3).
2. Press <ENTER> button.
The [COLOR TEMPERATURE] screen will be
z
displayed.
3. Press ▲▼ to select [COLOR
TEMPERATURE NAME CHANGE].
4. Press <ENTER> button.
The [COLOR TEMPERATURE NAME
z
CHANGE] screen will be displayed.
COLOR TEMPERATURE NAME CHANGE
PICTURE menu
Adjustment
range
Maximum
value
HIGH : 255
LOW : 127
Minimum
value
HIGH : 0
LOW :
- 127
Default
HIGH : 255
LOW : 0
Æ page 89). Be sure to
ENGLISH -
55