Hdmi In; Sdi In (Pt-Dz110Xe/Pt-Ds100Xe Only); On-Screen Display; Sdi - Panasonic PT-DS100XE Operating Instructions Manual

DISPLAY OPTION menu
6 ) Press ◄► to switch [DVI SIGNAL
LEVEL].
The setting will change as follows each time
z
◄► is pressed.
0-255 : PC
Select this when, for example,
an external device (PC, etc.) is
0-255 : PC
connected via the DVI terminal
output.
Select this when, for example, an
external device (DVD player, etc.)
16-235
is connected via the HDMI terminal
output using a conversion cable.
Note
The optimal setting differs depending on the output
z
setting of the connected external device. Refer to the
instruction manual of the external device.
If the setting is changed, the data for plug and play
z
changes. For the plug and play compatible resolutions,
refer to "List of compatible signals" (

HDMI IN

Change this setting if video does not display normally
when the projector and an external device are
connected via HDMI.
1 ) Press ▲▼ to select [HDMI IN].
2 ) Press <ENTER> button.
The [ HDMI IN] screen will be displayed.
z
3 ) Press ◄► to switch [HDMI SIGNAL
LEVEL].
The setting will change as follows each time
z
◄► is pressed.
0-1023
Select this when, for example, a DVI
terminal output of an external device
0-1023
(PC etc.) is connected to HDMI IN
using a conversion cable, etc.
Select this when, for example,
an HDMI terminal output of an
64-940
external device (DVD player, etc.) is
connected to HDMI IN.
Note
The optimal setting differs depending on the output
z
setting of the connected external device. Refer to the
instruction manual for the external device.
The displayed HDMI signal level is the value when the
z
input is 30 bit.
74
- ENGLISH
You can select signal amplitude type.
Available with YP
1 )
16-235
2 )
3 )
Æ page 123).
The user can specify the on-screen display.
1 )
2 )
3 )
J
64-940
SDI IN
(PT-DZ110XE/PT-DS100XE only)
P or RGB of HD-SDI signal.
B R
Press ▲▼ to select [SDI IN].
Press <ENTER> button.
The [ SDI IN] screen will be displayed.
z
Press ◄► to switch [SDI SIGNAL
LEVEL].
The setting will change as follows each time
z
◄► is pressed.
64-940
64-940 Normal setting
For when grey color is too close to
4-1019
black

ON-SCREEN DISPLAY

Press ▲▼ to select [ON-SCREEN
DISPLAY].
Press <ENTER> button.
The [ON-SCREEN DISPLAY] screen will be
z
displayed.
Press ▲▼ to select the desired item,
and press ◄► to change the setting.
OSD POSITION
This sets the position of the on-screen display
(OSD).
2 (Left center
of the screen)
1 (Top left
of the screen)
9 (Bottom right
of the screen)
8 (Right center
of the screen)
4-1019
3 (Bottom left
of the screen)
4 (Top center
of the screen)
5 (Center
of the screen)
6 (Bottom center
of the screen)
7 (Top right
of the screen)