Chapter 3 Basic Operations — Operating with the remote control
Using the function button
[SUB MEMORY], [SYSTEM SELECTOR], [DAYLIGHT VIEW], or [TEST PATTERN] operations can be assigned to the <FUNCTION> button on
the remote control so that it can be used as an easy shortcut button.
button
1)
Press the <FUNCTION> button.
Note
f Assignment of the function is performed from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON] (x page 90).
Using the status function
You can display the status of the projector.
button
1)
Press the <STATUS> button.
f The [STATUS] screen is displayed.
Note
f This can be displayed from the [PROJECTOR SETUP] menu → [STATUS] (x page 92).
Using the ECO management function
You can display the setting screen relating to ECO management.
button
1)
Press the <ECO> button on the remote control.
Note
f Refer to the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] (x page 85) for details.
STATUS
INPUT
RGB2
SIGNAL NAME
SXGA60+-A1
SIGNAL FREQUENCY
65.22kHz/ 59.99Hz
PROJECTOR RUNTIME
1h
LAMP: ECO
100h
: NORMAL
200h
: TOTAL
300h
INTAKE AIR TEMP.
27°C/ 80°F
AROUND LAMP TEMP.
27°C/ 80°F
SEND STATUS VIA E-MAIL
ENTER
CHANGE
EXIT
MENU
1/4
ENGLISH - 53