No Signal Shut-Off; Remote2 Mode; Function Button; Date And Time - Panasonic PT-DS100XE Operating Instructions Manual

NO SIGNAL SHUT-OFF

You can set the timer to switch off the power of the
projector after a certain period of time automatically
when no signal is detected.
1 ) Press ▲▼ to select [NO SIGNAL
SHUT-OFF].
2 ) Press ◄► to switch [NO SIGNAL
SHUT-OFF].
Deactivate the NO SIGNAL

DISABLE

SHUT-OFF.
10MIN. - 90MIN. At intervals of 10 minutes.

REMOTE2 MODE

You can customize the [REMOTE 2 IN] terminal
function.
1 ) Press ▲▼ to select [REMOTE2 MODE].
2 ) Press ◄► to switch [REMOTE2
MODE].
The setting will change as follows each time
z
◄► is pressed.

DEFAULT

USER
The pin assignment of the [REMOTE
DEFAULT 2 IN] terminal is used as the projector
default setting. (
This is used for changing the settings
for the REMOTE2 terminal.
USER Any settings you make for pins 2
to 8 become valid once you press
<ENTER> button.
L6500 Use the setting for L6500-compatible
SERIES REMOTE 2 terminal.
L6500 SERIES
Æ page 121)
PROJECTOR SETUP menu

FUNCTION BUTTON

You can assign a certain menu function to the
<FUNCTION> button as shortcut.
1 ) Press ▲▼ to select [FUNCTION
BUTTON].
2 ) Press <ENTER> button.
The [FUNCTION BUTTON] screen will be
z
displayed.
3 ) Press ▲▼ to select a function.
DISABLE Deactivate the <FUNCTION> button.
Changes between OFF/USER1/
P IN P USER2/USER3 in P IN P.
( Æ page 88)
SUB Displays the assigned SUB MEMORY
MEMORY LIST. ( Æ page 91)
SYSTEM Switches [SYSTEM SELECTOR]
SELECTOR options. ( Æ
SYSTEM
Switches [SYSTEM DAYLIGHT
DAYLIGHT
VIEW] options. (
VIEW
FREEZE Freezes the image.
WAVEFORM Displays the waveform of the input
MONITOR signal.
Û
: PT-DZ110XE only
Û
4 ) Press <ENTER> button.

DATE AND TIME

This lets you set the time zone and the current date
and time for the projector's internal clock.
Setting the TIME ZONE
J
1 ) Press ▲▼ to select [DATE AND TIME].
2 ) Press <ENTER> button.
3 ) Press ▲▼ to select [TIME ZONE].
4 ) Press ◄► to switch [TIME ZONE].
Adjusting the date and time
J
manually
1 ) Press ▲▼ to select [DATE AND TIME].
2 ) Press <ENTER> button.
3 ) Press ▲▼ to select [ADJUST CLOCK].
page 58)
Æ page 56)
ENGLISH -
85