Projector Setup Menu; Projector Id; Installation; High Altitude Mode - Panasonic PT-DS100XE Operating Instructions Manual

PROJECTOR SETUP menu

PROJECTOR SETUP menu
See "Navigating through the menu"
z
Æ
( page 50).
See "MAIN MENU" and "SUB MENU"
z
( Æ page 51).

PROJECTOR ID

The projector has an ID number setting function that
helps the user to control two or more projectors either
simultaneously or separately with a single remote
control.
1 ) Press ▲▼ to select [PROJECTOR ID].
2 ) Press ◄► to switch [PROJECTOR ID].
The setting will change as follows each time
z
◄► is pressed.

ALL

64
Note
The ID number can be set to [ALL], or selected from [1]
z
to [64].
If the projectors are given ID numbers, their remote
z
controls must be assigned the same ID numbers,
respectively.
If the ID number of a projector is set to [ALL], it can be
z
controlled by the remote control or the PC with any ID
number.
If multiple projectors are used and some of them
have their IDs set to "ALL", they cannot be controlled
separately from the projectors with other ID numbers.
For details on remote control ID setting, refer to "Setting
projector ID number to remote control" (

INSTALLATION

A projection scheme can be chosen depending on
the installation of the projector. If the picture is shown
upside down or in reverse, change the projection
scheme.
Select the setting by displaying the on-screen
z
indications using buttons of the remote control or
the control panel on the main unit.
76
- ENGLISH
1 ) Press ▲▼ to select [INSTALLATION].
2 ) Press ◄► to switch [INSTALLATION].
z

FRONT/FLOOR

REAR/CEILING
FRONT/
FLOOR
FRONT/
CEILING
FLOOR
CEILING

HIGH ALTITUDE MODE

If you use the projector at high elevation (1 400 m to
2 700 m), the [HIGH ALTITUDE MODE] setting needs
to be [ON] to set the fan speed high.
1
1 ) Press ▲▼ to select [HIGH ALTITUDE
MODE].
2
2 ) Press ◄► to switch [HIGH ALTITUDE
MODE] and press <ENTER> to select.
z
Æ page 21).
3 ) When the confirmation message is
displayed, select [OK] or [CANCEL].
Note
The loudness of fan noise depends on the [HIGH
z
ALTITUDE MODE] setting.
The separately-sold Smoke Cut Filter cannot be used
z
when the [HIGH ALTITUDE MODE] is [ON].
The setting will change as follows each time
◄► is pressed.
Setting on a desk/floor and
projecting from front
Mounting on the ceiling and
projecting from front
REAR/ Setting on a desk/floor and
projecting from rear
REAR/ Mounting on the ceiling and
projecting from rear
The setting will change as follows each time
◄► is pressed.

OFF

Select this when using in normal
OFF environment (less than 1 400 m
above sea level)
Select this when using at high
ON altitude (above 1 400 m and less
than 2 700 m above sea level)
FRONT/CEILING
REAR/FLOOR
ON