Removing and Replacing Components
Individual Component Remove/Replace Instructions
Front Bezel Replacement (Single Piece)
The rp54xx server front bezel is hinged on the left (facing the front of the server). The server does not have to
be turned off to open or to completely remove the bezel.
The bezel encloses the following components:
•
HotPlug Disks (A0, A1, and B0, B1).
•
Removable Media (CD-ROM drive, etc.).
•
HotSwap Chassis Fan cover.
•
HotSwap Chassis Fan 0.
•
HotSwap Power Supplies (up to three).
To attach the bezel, perform the following steps:
1. Screw the bezel hinge to the threaded inserts on the left side of the server.
2. Install the hinge cover by aligning the notch in the top of the cover with the top of the assembly cover and
press firmly into place.
The following graphic shows the front bezel.
136
Chapter 7