Rp5470 Pci Card Slots - HP L1000 - 9000 - 0 MB RAM User Manual

rp5470 PCI Card Slots

For rp5470 models, the 10 PCI I/O slots consist of Twin Turbo, Turbo, and non-Turbo slots. The following
illustration shows the PCI card slot layout.
• Slots 1 and 2 are reserved for the rp54xx LAN/SCSI and GSP (Guardian Service Processor) Core I/O
cards, respectively. Slots 1 and 2 are non-Turbo slots. Non-Turbo slots share a single 250MB/s PCI bus
and are incapable of HotPlug functionality. The server must be turned off prior to removing or installing
the LAN/SCSI or GSP cards in these slots.
• Slots 3 and 4 are non-Turbo slots. These two Non-Turbo slots share a single 250MB/s PCI bus, run at
33MHz and support 32 and 64-bit PCI cards. Non-Turbo slots are incapable of HotPlug functionality. The
server must be turned off prior to removing or installing PCI cards in these slots.
• Slots 5 - 10 are Turbo slots. Each Turbo slot has a dedicated 250MB/s PCI bus, run at 66MHz and support
32 and 64-bit PCI cards. Turbo slots are HotPlug capable. Below each Turbo slot is a plastic PCI card
separator. The PCI card separator has two LEDs and a pull tab on the outer edge. The LED's provide
power and status for the slot. The pull tab allows the PCI card to be easily removed.
• Slots 11 and 12 are Twin Turbo slots. Each Twin Turbo slot has a dedicated 500MB/S PCI bus, runs at 66
MHz, and supports 32- and 64-bit PCI cards. Twin Turbo slots are HotPlug capable. Below each Twin
Turbo slot is a plastic PCI card separator. The PCI card separator has two LEDs and a pull tab on the
outer edge. The LED's provide power and status for the slot and the pull tab allows the PCI card to be
easily removed.
rp5470 servers have access to all (1-12) slots.
Chapter 3
Installing Peripheral Component Interconnect (PCI) Cards
rp5470 PCI Slots
Installing Additional Components
31