Front Bezel - HP ProLiant DL585 Maintenance And Service Manual

Front bezel

To remove the front bezel:
1.
Power down the server. See "Powering down the server" earlier in this chapter.
2. Extend the server from the rack. See "Extending the server from the rack" earlier in this chapter.
3. Remove the access panel. See "Removing the access panel" earlier in this chapter.
4.
Using the T-15 Torx tool, remove the six screws on the exterior of the chassis and the two screws on the interior
of the chassis next to the universal media drive bays.
Figure 30 Removing the exterior and interior chassis screws
5. Using a flathead screwdriver, disengage the locking tabs on the bezel from under the chassis.
6.
Remove the front bezel.
Figure 31
Disengaging the locking tabs and removing the front bezel
Reverse the steps to replace the front bezel.
All manuals and user guides at all-guides.com
Removal and replacement procedures 35