Pci Card Separator/Extractor Removal - HP L1000 - 9000 - 0 MB RAM User Manual

Removing and Replacing Components
Individual Component Remove/Replace Instructions

PCI Card Separator/Extractor Removal

PCI card separator/extractors are located in the Side Service Bay, between the PCI cards. PCI card
separator/extractors are plastic cards with two tab handles and two LEDs.
Before removing a PCI card separator/extractor from the server, perform the following tasks:
• Shut down the server.
• Remove the corresponding PCI card.
To remove a PCI card separator/extractor, perform the following steps:
1. Carefully slide a long shaft, medium width, flat blade screw driver (item 1) into the Side Service Bay
along the side of the PCI card separator/extractor, and insert it into the slot in the hook tab (item 2).
2. At the point where the PCI card separator/extractor inserts into the PCI backplane connector (item 2),
there are two slotted, hook tab connectors on the PCI card separator/extractor, one on either side of the
PCI Backplane connector. Press one then the other to disengage the card from the backplane.
3. With the two connection points pressed, slide the PCI card separator/extractor out of the PCI card cage.
142
1
2
Chapter 7