Secure Web Console Installation - HP L1000 - 9000 - 0 MB RAM User Manual

Cable Connections

Secure Web Console Installation

Secure Web Console Installation
The following section describes installation of the HP Secure Web Console on inside of the rear door of a
rack-mounted rp54xx server.
For technical, installation, and configuration instructions for the Secure Web Console, refer to the following
URLs on the Internet:
General information:
http://www.hp.com/
Documentation:
http://www.docs.hp.com
NOTE Either the system console (HP series 700 terminal) or the HP Secure Web Console may be
installed on an rp54xx server, but not at the same time. Both console types use the same DB9
type LAN Console connector.
Cabinet
To install the HP Secure Web Console on an rp54xx server, refer to the previous figure and the HP Secure
Web Console documentation, then proceed as follows:
Step 1. Install the wire mounting bracket by carefully inserting the two top prongs through the vent grill in
the rear door of the cabinet as shown above. Position the bracket toward the hinge side of the door.
66
Chapter 4