Top Cover Removal - HP L1000 - 9000 - 0 MB RAM User Manual

Top Cover Removal

The power to the server does not have to be off to remove the top cover and air baffle. However, operation of
the server without the top cover in place can make it susceptible to EMI problems.
Follow the steps listed below to remove the top cover:
1. Loosen the captive T-15 screws that hold the top cover in place.
2. Grasp the strap handles, raise the cover slightly, and pull the cover toward the front of the server to free
the cover tabs from the slots in the chassis. The air baffle will be exposed.
Loosen the captive T-15 screws that hold the air baffle in place then lift the air baffle off of the server.
The following graphics show the top service bay cover and the air baffle. The first graphic shows the top
service bay cover.
The second shows the air baffle.
Chapter 7
Removing and Replacing Components
Individual Component Remove/Replace Instructions
131