Install Deskside Server - HP L1000 - 9000 - 0 MB RAM User Manual

Server Unpacking and Installation

Install Deskside Server

Install Deskside Server
The following section describes the installation of a server into a Deskside enclosure for installation in an
office environment.
The typical rp54xx system can weigh up to 68kg (150lbs). HP recommends using an
WARNING
approved lifting device.
• Lift and move the server in accordance with all local safety regulations.
• Do not attempt to lift the server by the plastic handles on the top and side covers.
Failure to follow these precautions can cause injury to personnel or damage to
equipment.
Step 1. Unpack the server.
Step 2. Unpack the deskside enclosure.
Enclosure
Outside
Cover
(Skin)
NOTE
10
Ensure that the positioning spring pins in the enclosure base align with the
alignment holes in the bottom of the server.
Server
Wheeled
Enclosure
Base
Chapter 2