Hotswap Power Supply Removal - HP L1000 - 9000 - 0 MB RAM User Manual

Removing and Replacing Components
Individual Component Remove/Replace Instructions

HotSwap Power Supply Removal

Up to three power supplies (0 through 2), located across the bottom front of the server, can be installed in the
server without removing power.
To remove a power supply from the server, perform the following step:
1. Remove the T-15 mounting screw located to the right of the handle near the top of the power supply.
Be careful when pulling the power supply out of the server. It is heavier than it appears.
CAUTION
2. Grasp the handle and pull the power supply out of the server.
The following graphic shows a front and rear view of a HotSwap Power Supply.
158
Chapter 7