HotSwap Power Supply Replacement
Up to three power supplies (0 through 2), located across the bottom front of the server, can be installed in the
server without removing power.
To replace a power supply, perform the following steps:
CAUTION
Be careful when putting the power supply into the server. It is heavier than it appears.
1. Grasp the handle in one hand and support the power supply with the other. Slide the power supply into
the server. The Power Supply LED should illuminate immediately.
2. Replace the T-15 mounting screw located to the right of the handle near the top of the power supply.
The following graphic shows a front and rear view of a HotSwap Power Supply.
Chapter 7
Removing and Replacing Components
Individual Component Remove/Replace Instructions
159