PCI Card Separator/Extractor Replacement
PCI card separator/extractors are located in the Side Service Bay on the PCI Backplane, between PCI cards.
PCI card separator/extractors are plastic cards with two tab handles and two LEDs.
To replace a PCI card separator/extractor, perform the following steps:
1. Insert the PCI card separator/extractor into the available slot and slide it into the PCI backplane
connector.
2. Be sure the two hook tabs on the PCI card separator/extractor insert into the connector blocks on either
side of the PCI backplane.
Once you have completed replacement of the PCI card separator/extractor into the server, perform the
following tasks:
•
Replace the PCI card, if necessary.
•
Power up the server.
Chapter 7
Removing and Replacing Components
Individual Component Remove/Replace Instructions
143