IMPORTANT: When the server is in standby mode, auxiliary power is still being provided to
the system.
To power down the server, use one of the following methods:
•
Press and release the Power On/Standby button.
This method initiates a controlled shutdown of applications and the OS before the server enters
standby mode.
•
Press and hold the Power On/Standby button for more than 4 seconds to force the server to enter
standby mode.
This method forces the server to enter standby mode without properly exiting applications and the
OS. If an application stops responding, you can use this method to force a shutdown.
•
Use a virtual power button selection through iLO.
This method initiates a controlled remote shutdown of applications and the OS before the server
enters standby mode.
Before proceeding, verify the server is in standby mode by observing that the system power LED is
amber.
Power up the server
To power up the server:
Connect each power cord to the server.
1.
Connect each power cord to the power source.
2.
Press the Power On/Standby button.
3.
The server exits standby mode and applies full power to the system. The system power LED
changes from amber to green.
Unlock the front bezel
Using the key provided with the server, unlock the bezel with a clockwise turn.
Removal and replacement procedures 25