Processor Support Module Replacement - HP L1000 - 9000 - 0 MB RAM User Manual

Processor Support Module Replacement

Processor Support Modules (PSMs) (there can be two PSMs, numbered 0 and 1) reside on the System Board
and are accessed via the Top Service Bay. Looking into the Top Service Bay from the front, PSMs are located
on either side of the server, at the front.
To replace a PSM, perform the following steps:
1. Seat the PSM into its socket.
2. Tighten the two captive mounting screws that hold the PSM in place.
NOTE For the rp5470, the mounting screws have been replaced by posts and the air baffle is used
to secure the PSM's.
The following graphic shows a PSM in the server.
Chapter 7
Removing and Replacing Components
Individual Component Remove/Replace Instructions
163