Protocol Setup (Token Ring) - EFI Pi6500 Pro Configuration Manual

3
3-12 Setting up the Pi6500 Pro from a Windows Computer
IP Address (Ethernet)
change the default
about setting up printing with TCP/IP, see Chapter 4.
Subnet Mask (Ethernet)
following values:
• if the IP address starts with a number less than 128
255.0.0.0
• 255.255.0.0
•
255.255.255.0
Be sure to confirm the subnet mask setting with your network administrator
N :
OTE
before proceeding. In some cases the required setting may be different from those
listed.

Protocol Setup (Token Ring)

Enable on Token Ring
Pi6500 Pro over Token Ring. If you use Token Ring, enabling TCP/IP for Token
Ring is required for enabling the Fiery WebTools.
If you are using TCP/IP for printing from Windows NT 4.0 workstations, enabling
TCP/IP here also enables you to use Fiery utilities from Windows NT 4.0 worksta-
tions using TCP/IP protocols.
IP Address (Token Ring)
change the default to a valid address for your network.
IP Auto (Token Ring)
IP address by searching the network. Depending on your network and the protocol
you select (DHCP, BOOTP, or RARP), the IP address can change.
Select protocol (Token Ring)
search for its IP address. Both DHCP and BOOTP allow the Pi6500 Pro to obtain the
Token Ring IP address and Subnet Mask automatically. RARP obtains only the Token
Ring IP address.
Depending on your network, the Pi6500 Pro might be assigned a different address
after you reboot the Pi6500 Pro. With the DHCP setting, the Pi6500 Pro can be
assigned a different address even if it is not rebooted. Make sure the network is already
configured properly for the protocol you select.
—Enter the Pi6500 Pro IP address for Ethernet. You must
to a valid address for your network. For information
127.0.0.1
—If you need to set the subnet mask, enter one of the
if the IP address starts with a number from 128 through 191
if the IP address starts with a number greater than 191
—Select if you have a TCP/IP network connected to the
—Enter the Pi6500 Pro IP address for Token Ring. You must
—Click to allow the Pi6500 Pro to obtain its Token Ring
—Select the protocol over which the Pi6500 Pro should