Protocol Setup (Ipx Frames) - EFI Pi6500 Pro Configuration Manual

2
2-20 Setting up the Pi6500 Pro
Network Setup
Protocol Setup
TCP/IP Setup
Gateway Setup options
If your TCP/IP network has a gateway, and users outside the gateway print to the
Pi6500 Pro using TCP/IP, choose Gateway Setup and enter the gateway address.
Gateway Setup
Get Gateway Address Automatically
Yes/No [No]
Use this option to get the gateway address automatically for printing with TCP/IP.
This option appears only if you selected DHCP or BOOTP as the protocol (see
page 2-16).
If you select a DHCP or BOOTP protocol and later change it to RARP, you must
return to Gateway Setup and set Get Gateway Address Automatically to No. You can
then set the address manually. This is because RARP does not support automatic
assignment of the gateway address.
Gateway Address
[127.0.0.1]
This option appears only if you answered No to Get Gateway Address Automatically,
or if you selected RARP as the protocol.
Set the gateway address for printing with TCP/IP. After setting the gateway address,
proceed to set up Token Ring, if applicable, or choose Exit TCP/IP Setup and proceed
to Service Setup.
Set the gateway address for printing with TCP/IP. After setting the gateway address,
choose Exit TCP/IP Setup and proceed to Service Setup.