Before You Begin - EFI Pi6500 Pro Configuration Manual

1

1-11 Before you begin

Before you begin
The following steps should be completed before you configure the Pi6500 Pro and the
workstations that will print to the Pi6500 Pro. A service technician will have
performed some initial installation.
T P 6500 P
O PREPARE FOR I
1. Print a copier test page to make sure the copier is functioning normally.
2. Turn off the copier and connect the interface cable from the copier to the Pi6500 Pro.
3. To confirm this connection, turn on the copier and the Pi6500 Pro and print a Test
Page from the Control Panel.
To print a Test Page, press the Menu button on the Control Panel to display the
Functions menu. (See "Pi6500 Pro Control Panel" on page 2-3.) Choose Print Pages,
and then Test Page.
4. With both the copier and Pi6500 Pro turned off, connect the network cable to the
Pi6500 Pro, as described in the next section.
The network should already be installed and operational.
5. Turn on the copier and then the Pi6500 Pro.
6. Prepare network servers to share Pi6500 Pro user software and to enable networked
users to print to the Pi6500 Pro, and proceed to Setup.
See Chapters 2 and 3 for details.
RO CONFIGURATION