Table of Contents
Advertisement
2
2-14 Setting up the Pi6500 Pro
Exit Protocol Setup
AppleTalk Setup
TCP/IP Setup
IPX/SPX Setup
Protocol Setup
Network Setup
Protocol Setup
Exit TCP/IP Setup
Ethernet Setup
Token Ring Setup
Gateway Setup
TCP/IP Setup
Exit TCP/IP Setup
Ethernet Setup
TCP/IP Setup
Protocol Setup options
To configure the Pi6500 Pro, choose each protocol and enter the settings for that
protocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communication
simultaneously.
AppleTalk Setup
Enable AppleTalk
Yes/No [No]
Select Yes if you have an AppleTalk network connected to the Pi6500 Pro. This setting
enables the Pi6500 Pro to communicate over AppleTalk networks.
AppleTalk Zone
List of zones
The Pi6500 Pro searches the network for AppleTalk zones in your network segment.
Scroll through the list to select the AppleTalk zone in which you want the Pi6500 Pro
to appear. If your segment has only one zone, the Pi6500 Pro is assigned to that zone
automatically.
The message "No AppleTalk zone found" may mean your network has no zones, or the
network cable is not connected (see page 5-4). Choose OK.
TCP/IP Setup options
Enter the appropriate settings for the network type you use (Ethernet or Token Ring).
Token Ring Setup appears as an option only if you have enabled Token Ring in Port
Setup. If your network uses a gateway, enter the gateway address in Gateway Setup.
For information about setting up printing with TCP/IP, see Chapter 4.
Enter the appropriate settings for Ethernet.
For information about setting up printing with TCP/IP, see Chapter 4.
To configure the Pi6500 Pro for TCP/IP, choose TCP/IP Setup.
Advertisement
Table of Contents
