Port Setup Options - EFI Pi6500 Pro Configuration Manual

2
2-11 Network Setup options
4. To use Ethernet, choose Ethernet Setup from the Port Setup menu, and enter the
5. If the Token Ring option is installed, choose Token Ring Setup and enter the
6. To print to the parallel port, choose Parallel Port Setup from the Port Setup menu, and
7. When you have finished entering port settings, choose Exit Port Setup and then choose
8. Enter the appropriate settings for the protocol or protocols you will use.
9. When you have finished entering protocol settings, choose Exit Protocol Setup and
10. Enter the appropriate settings for the services you will use.
T N
O EXIT ETWORK
1. When you have finished entering service settings, choose Exit Service Setup, then Exit
2. Choose Yes when prompted to save changes.
3. From the main Setup menu, choose another Setup or choose Exit Setup.
Exit Port Setup
Ethernet Setup
Token Ring Setup
Parallel Port Setup
Port Setup
appropriate settings.
appropriate settings.
enter the appropriate settings.
Protocol Setup.
then choose Service Setup.
The options are described in detail in the following pages.
S
ETUP
Network Setup.

Port Setup options

You can enable Ethernet or Token Ring (if the Token Ring option is installed), but
not both at the same time. You can also enable parallel communication
simultaneously with either Ethernet or Token Ring. To configure the Pi6500 Pro,
choose each port type you use and enter the settings for that port. Since network
Setups are nested, the names of higher-level menus are shown in this chapter to the
left of each menu heading.