Table of Contents
Advertisement
2
2-1 About Pi6500 Pro Setup
Chapter 2:
Setting up the
Pi6500 Pro
The Pi6500 Pro fits into a variety of work environments. To prepare for printing at
your site, you need to do some initial configuration to specify the network
environment and the kind of printing you will do.
About Pi6500 Pro Setup
When the copier is turned on after new system software is loaded, you (or the service
technician who loads the software) choose the language you want to use for Control
Panel menus and messages. After that, the Server, Network, Printer, PCL, PS, and Job
Log Setups, in that order, can be configured from the Control Panel.
On Novell or Windows NT (using TCP/IP) networks, the network servers should be
configured for printing to the Pi6500 Pro before you enter network settings on the
Pi6500 Pro. The diagrams on pages 1-5 through 1-10 give chapter references for
Network Setup.
For Setup, you need a live network connection so the Pi6500 Pro can query the
network for zones, servers, server-based queues, and other essential information. When
you set an IP address, subnet mask, or gateway address for the Pi6500 Pro during
Setup, you can allow the Pi6500 Pro to get these addresses automatically.
Whenever the configuration of the Pi6500 Pro, a copier, or the network itself changes
at your site, you can alter individual settings to correspond to the changed
environment. Likewise, if printing needs or administrative requirements change, you
can alter the corresponding settings.
Changing network or port settings may require that you make changes in more
N
:
OTE
than one Setup area.
Advertisement
Table of Contents
