Protocol Setup (Tcp/Ip) - EFI Pi6500 Pro Configuration Manual

3
3-11 Network Setup

Protocol Setup (TCP/IP)

Enable on Ethernet
Pi6500 Pro over Ethernet cabling.
You must enable TCP/IP for Ethernet to use the Fiery WebTools over Ethernet. If you
are using TCP/IP for printing from Windows NT 4.0 workstations, enabling TCP/IP
here also enables you to use Fiery utilities from Windows NT 4.0 workstations using
TCP/IP protocols.
IP Auto (Ethernet)
by searching the network. Depending on your network and the protocol you select
(DHCP, BOOTP, or RARP), the IP address can change.
Select protocol (Ethernet)
search for its IP address. Both DHCP and BOOTP allow the Pi6500 Pro to obtain the
Ethernet IP address and Subnet Mask automatically. RARP obtains only the Ethernet
IP address.
Depending on your network, the Pi6500 Pro might be assigned a different address
after you reboot the Pi6500 Pro. With the DHCP setting, the Pi6500 Pro can be
assigned a different address even if it is not rebooted. Make sure the network is already
configured properly for the protocol you select.
IP Static (Ethernet)
change.
—Click to enable if you have a TCP/IP network connected to the
—Click to allow the Pi6500 Pro to obtain its Ethernet IP address
—Select the protocol over which the Pi6500 Pro should
—Click to assign the Pi6500 Pro a static IP address that will not