Configuring A Windows Nt 4.0 Server To Support The Pi6500 Pro - EFI Pi6500 Pro Configuration Manual

4
4-12 Setting up Network Servers
• Make sure your system host table includes the correct internal name for the
Pi6500 Pro as a remote printer.
See page 4-19 for more information.
• Install the appropriate printer driver files (PCL or PostScript) on the Windows NT 4.0
server (see Getting Started).
• Repeat the installation for everyone who prints to the Pi6500 Pro.
Configuring a Windows NT 4.0 server to support the Pi6500 Pro
To configure a Windows NT 4.0 server to communicate with the Pi6500 Pro, follow
these general steps. More detail is provided in subsequent sections.
• Load the TCP/IP network protocol on the server and configure it with an
IP address, subnet mask, and gateway.
• Enter the host name of the Pi6500 Pro in the host database used by your system (see
page 4-13).
• On the Pi6500 Pro Control Panel, perform Server Setup (see page 2-7), Network
Setup (page 2-9), PS Setup (page 2-39), and PCL Setup (page 2-41).
• On the Windows NT 4.0 server, create a printer for each Pi6500 Pro print
connection, install the appropriate printer drivers (if necessary) and (optionally)
share the printer on the network (see page 4-14).
• Enter the host name and internal name of the Pi6500 Pro in the printer connection.
See Getting Started for more information.