Removing The Scsi Disk Pca - HP Visualize J5000 - Workstation Service Handbook

SCSI Disk PCA
Before removing the SCSI Disk PCA, open the system unit and remove the Storage
Assembly
Perform the following steps to remove the SCSI Disk PCA:
1. Unscrew the captive screw holding the EMI divider at the back of the removable
drives and lift the plate up and out of the drawer as shown in Figure 5–51
2. Remove the screw holding the peripheral baffle in place as shown in
Figure 5–52.
Figure 5–52. Removing the SCSI Disk PCA
3. Disconnect the SCSI signal and power cables from the SCSI Disk PCA.
4. Remove the screw holding the SCSI Disk PCA in the storage assembly and lift
the SCSI Disk PCA out of the storage assembly.
Reverse these steps to replace the SCSI Disk PCA.
Field Replaceable Units 5–57