Removing A Scsi Hard Disk Drive - HP x4000 Technical Reference Manual

Installing or Replacing Parts and Accessories
SCSI Hard Drive

Removing a SCSI Hard Disk Drive

To remove the SCSI hard disk drive:
1. Turn off the display and shut down the Workstation. Disconnect all
power cables and any LAN or telecommunications cables.
2. Remove the Workstation's cover (see page 145).
3. Open the hard disk drive cage (see page 149).
4. Remove the hard disk drive from the cage by removing the four torx
screws that hold the drive in place as shown in Figure 10-18.
Figure 10-18 Removing the Hard Disk Drive
168
This manual downloaded from http://www.manualowl.com
These 4 screws
(2 front, 2 back)
hold one hard
drive in place.
Screws for
installing a
second
hard disk
drive
Upper Bay
Lower Bay
Chapter 10